Victron VE.Direct Cable 10m Right Angle - ASS030531320
Victron VE.Direct Cable 10m Right Angle - ASS030531320
Genuine Victron long-range data cable
Victron VE.Direct Cable 10m (33ft) | Right Angle (ASS030531320)
A 90-degree VE.Direct cable with the maximum supported direct-run length for distant RV, marine, and off-grid components.
The Victron VE.Direct cable 10m right angle is a genuine Victron Energy data cable for installations that need both approximately 33 feet of reach and a low-profile connection. Part ASS030531320 combines one right-angle VE.Direct connector with one straight connector, helping link supported SmartShunts, BMV monitors, MPPT controllers, chargers, inverters, and GX devices across large compartments without crushing a straight cable behind a shallow panel.
Built for clean long-range Victron installations
The Perfect Solution for Tight Clearances
Reduce connector depth and mechanical stress when a straight cable would project too far from the device.
Shallow RV walls, marine helms, battery cabinets, and compact electrical boards can force a straight data cable into a sharp bend. The right-angle end routes the cable close to the device surface, reducing required rear clearance and helping protect the cable and VE.Direct port from constant pressure.
Space-Saving 90-Degree Connector
One end uses Victron’s low-profile right-angle VE.Direct connector. Place it at the device with the tightest clearance and route the wire along a protected surface rather than forcing a straight connector against a panel.
Protects Delicate Data Ports
Reducing sharp bends and side-load can lower mechanical stress on the molded connector and device port. Add strain relief and test the connector orientation before permanently mounting the Cerbo GX, MPPT, SmartShunt, or other component.
Long-Range System Networking at the 10-Meter Limit
Approximately 32.81 feet for components mounted in distant RV, marine, and off-grid compartments.
10 Meters (33 Feet) of Extended Reach
Route from a SmartShunt or MPPT in an RV basement to a GX device in the living cabin, from a marine battery compartment or engine room to a distant helm, or across a larger off-grid equipment area without field-spliced extensions.
Long-Run Communication Within Victron’s Limit
Ten meters is Victron’s maximum supported direct VE.Direct run. Use the factory cable as one uninterrupted path, add strain relief, and keep the unshielded, untwisted data cable separated from high-current AC/DC wiring, motors, and other interference sources where practical.
Compatible VE.Direct applications
Confirm a VE.Direct port on both devices before ordering.
- ✓ SmartShunt or BMV battery-monitor links to a Cerbo GX, Ekrano GX, or another compatible GX device.
- ✓ Compatible BlueSolar and SmartSolar MPPT controllers with VE.Direct ports.
- ✓ Supported Orion XS and Smart IP43 charger connections to a compatible GX device.
- ✓ Certain Phoenix and other supported VE.Direct inverter connections where the product manual calls for VE.Direct.
- ✓ Large RV installations routing from a basement battery or solar bay to an interior monitoring panel.
- ✓ Marine installations routing from an engine room or lower equipment compartment to a helm or cabin display.
- ✓ Off-grid cabins where the solar equipment room and central GX monitoring location are separated.
- ✓ Flush-mounted GX installations that need a low-profile cable exit at one end of a long run.
Genuine Victron Reliability for the Longest Direct Run
Exact part-number matching and factory termination for professional installations.
Long-run installation guidance
Test the right-angle orientation and plan the full 10-meter route before mounting your equipment.
- ✓ Place the right-angle end at the device with the tightest rear or side clearance.
- ✓ Confirm the molded cable-exit direction does not interfere with adjacent ports, mounting hardware, or enclosure covers.
- ✓ Maintain gentle bends and add strain relief near both connected devices and at intermediate support points.
- ✓ Route the data cable away from sharp edges, moving parts, standing water, and high-temperature surfaces.
- ✓ Separate communication wiring from high-current DC and AC cables where practical; cross power cables at right angles when necessary.
- ✓ Do not cut, splice, or daisy-chain VE.Direct extensions. Ten meters is the maximum direct cable length.
Technical specifications
Exact part identification, connector configuration, compatibility, and installation limits.
Check the port before you order
VE.Direct, VE.Bus, VE.Can, RJ12, and USB interfaces are different cable families.
Match the cable to the labels and connector shape on both devices. A physically similar communication cable may use a different connector, pinout, or protocol. Review both product manuals when designing a Victron or Epoch-integrated system.
Related Victron cable options
Choose the shortest factory cable that fits the route and connector-clearance needs.
Victron VE.Direct 10m Right-Angle Cable FAQs
Common questions about connector orientation, compatibility, signal reliability, and maximum-length routing.
Is 10 meters too long for a VE.Direct cable? Will I lose signal?
Ten meters is the maximum direct VE.Direct cable length supported by Victron. This genuine factory cable is intended for compatible point-to-point VE.Direct connections at that distance. Reliable operation still depends on correct device compatibility, undamaged connectors, proper routing, and avoiding extensions or splices.
Are both ends of this cable right-angled?
No. Victron part ASS030531320 has one standard straight VE.Direct connector and one right-angle connector. Use the angled end at the device with the tightest rear or side clearance.
Does it matter which end plugs into the Cerbo GX, SmartShunt, or MPPT?
Victron does not identify the cable as directional. In normal point-to-point VE.Direct use, place the right-angle end where clearance is tightest and the straight end where more space is available. Confirm the molded cable-exit direction before permanently mounting the device.
Will the right-angle connector block the port next to it on my Cerbo GX?
The right-angle design minimizes required depth behind mounting panels, but adjacent-port clearance depends on the exact device, connector orientation, and mounting position. Test-fit the connector and verify neighboring VE.Direct, USB, HDMI, power, and mounting access before final installation.
What is the difference between VE.Direct and VE.Bus or VE.Can?
VE.Direct is Victron’s smaller four-core data connection for supported battery monitors, MPPT solar chargers, Orion XS units, Smart IP43 chargers, and certain VE.Direct inverters. VE.Bus and VE.Can use RJ45-style network cables for different product families, including MultiPlus or Quattro systems and CAN networks. These cable families are not interchangeable.
Can I use this cable to connect an Epoch battery directly to a Cerbo GX?
No, not as a universal battery communication cable. Epoch batteries with native Victron or CANbus communication normally require the battery model’s specified CAN-BMS cable or harness connected to a VE.Can or BMS-Can port. This product is for devices that actually provide VE.Direct ports.
Which Victron products can use this cable?
It can connect compatible products equipped with VE.Direct ports. Common examples include supported BMV battery monitors, SmartShunts, BlueSolar or SmartSolar MPPT controllers, Orion XS units, Smart IP43 chargers, certain VE.Direct inverters, and compatible GX devices. Verify the port and manual for both products before ordering.
Can I cut, splice, or extend this 10-meter cable?
No. Victron states that VE.Direct cables cannot be extended. Do not cut, splice, daisy-chain, or add an inline extension. If more than 10 meters is required, use a VE.Direct-to-USB interface with an appropriate active USB extension as described by Victron.
What should I do with excess cable if I only need about 25 feet?
Do not shorten the cable by cutting it. Route the factory cable with gentle bends and secure any extra length in a loose service loop away from sharp edges, heat, moving parts, water, and high-current conductors. Avoid tightly coiling or crushing the cable behind a panel.
Is this cable covered by a warranty?
Victron currently provides a standard five-year warranty on its power-product range, subject to its warranty terms and original-dealer support process. Keep your proof of purchase and contact the selling dealer for warranty assistance.